Avoid over-tightening: You need a secure connection, but you shouldn’t overtighten the push fittings, as this could cause leaks.Secure the threaded ends with plumber’s or Teflon tape, preventing leaks Use flex piping to attach the filter to your water line, and use push fittings and adaptors if your pipe size is too small or big for the unit’s plumbing connections. Mount the unit: Install the filer, making sure the “in” and “out” ports are facing the right way.Install the wall mount: Attach the wall mount to your wall (if your filter comes with one).Pressure gauges allow you to monitor the ingoing and outgoing water pressure around the unit, which is helpful for knowing when to change the filters Install pressure gauge: Also consider installing a pressure gauge.Bypass valves give you access to water even while the filter is out of use Some units come with an included valve, but in most cases, you’ll need to pay extra for one. Install bypass: Consider installing a bypass valve alongside the shut off valve.This means that you can easily shut off water leading to and from the unit during maintenance, or in response to an emergency Install shutoff valves: Install a shutoff valve on either side of the unit.Sand the pipe: Place the cut section of the pipe to the side and sand both cut ends of the pipe, then pick out any installation debris from the inside of the pipe.Hold a bucket underneath the water line to catch any remaining water in the pipe Cut into the main water line: Use a pipe cutter or a similar tool to cut into your main water line, removing a big enough section to fit the filter housing.Shut off the water: Shut off the water supply into your home, and open all your faucets to drain water and release trapped air from the pipes. Here’s the step-by-step process to follow: Once you’ve chosen your location on your main water line, you can get started with a do-it-yourself installation. If you’re installing a filter for a home with a private well, make sure the filter is installed after the pressure tank. You need to be able to comfortably install the system, and easily access the filter housings or tanks when it’s time to replace the filters or media. Your chosen location should have plenty of space. So, you need to choose a location as close as possible to your water pipe’s entry point into your home, upstream of your water heater. The purpose of a whole home filter is to provide your entire water supply, including your hot water heater, with filtered water.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |